Collection: Motor Start Capacitors
Motor Start Capacitors are used to boost the starting torque of single-phase electric motors by increasing the current through the start windings during startup. They typically only stay in the circuit for a few seconds before being switched off by a centrifugal or electronic switch inside the motor. If your single-phase motor will not start, very often, the start capacitor (if it has one), could be bad. It is a common failure mode in single phase motors.
A single phase motor will usually have both starting capacitors and run capacitors. Run capacitors have a smaller capacitance rating than a starting capacitor and are designed for continuous duty operation because they stay in the circuit all the time. It is important to never use a start capacitor as a replacement for a run capacitor because start capacitors are not designed for continuous duty.
Caldwell Electric can diagnose electric motor problems and offer solutions for repair or replacement. Start capacitors can also be purchased directly from our web site on this page.
Selecting a Start Capacitor
The two most important values when replacing a capacitor are capacitance and voltage rating. Physical size is the third criteria.
- Capacitance: For electric motors this is measured in microfarads. This is usually printed on the capacitor as a number, or number-range, followed by the letters MFD, or uF. The replacement capacitor should match the original capacitance as close as possible.
- Voltage Rating: A replacement capacitor must have a voltage rating that is at least as much as the original capacitor. It is ok and actually better if the replacement capacitor has a higher voltage rating than the original. However, higher voltage ratings usually result in an overall larger capacitor. So size should also be considered.
- Size: They physical size of the replacement capacitor should be such that it can fit in the motor capacitor housing. Typically increasing either the capacitance or the voltage will result in a larger capacitor.
-
QE Quality Start Capacitor 829-995 MFD 110 VAC
Regular price $15.95Regular priceUnit price / per -
QE Quality Start Capacitor 270-324 MFD 330 VAC
Regular price $13.95Regular priceUnit price / per -
QE Quality Start Capacitor 340-408 MFD 220 VAC
Regular price $15.95Regular priceUnit price / per -
QE Quality Start Capacitor 378-454 MFD 110 VAC
Regular price $10.36Regular priceUnit price / per -
QE Quality Start Capacitor 460-552 MFD 110 VAC
Regular price $11.10Regular priceUnit price / per -
QE Quality Start Capacitor 161-193 MFD 220 VAC
Regular price $12.50Regular priceUnit price / per -
QE Quality Start Capacitor 216-260 MFD 220 VAC
Regular price $12.50Regular priceUnit price / per -
QE Quality Start Capacitor 1000-1200 MFD 110 VAC
Regular price $12.75Regular priceUnit price / per